Aluminum wall panels are very popular in recent years. These aluminum veneers are used as decoration materials for exterior walls and made of thick aluminum plate coated by fluorocarbon, which can resist ultraviolet, humidity, temperature and air pollution and never fade. Curtain wall aluminum veneer are light weight, easy to be installed and have an excellent buckling strength and wind-resistant performance. According to the size of partition and requirement of building, the curtain wall panel is usually made of aluminum plate with thickness between 2.0-3.0mm. They can be easily shaped and the use of reinforcing bar technique intensifies their capacity to bear the wind load. Thus it is possible to make a aluminum plate layer of extraordinary size.

 

Curtain wall aluminum veneer produced by fluorocarbon baking paint is now acid and alkali resistance, corrosion resistance, resistance to yellow uv resistance, weather resistance is the best high-grade environmental decorative materials, paint surface texture is delicate, uniform color and color, always new, quality reached the international advanced level of similar products. Especially suitable for large high-rise buildings,roofing, curtain wall, solar energy equipment and other high-end decoration projects.

 

 

 

1. Light weight, good rigidity, high strength;

2. Strong weather resistance and corrosion resistance;

3. Good machine ability, it can be machined into complicated shapes such as flat plate, arc plate and hyperbolic panel;

4. Color can choose a wide range, conducive to collocation;

5. Self-cleaning ability, low maintenance cost;

6. Long service life, coating shelf life of more than 15 years;

7. Convenient installation and construction;

8. High safety, no peeling, no peeling;

9. Recyclable reuse,high recycling value, good for environmental protection.

 

 

Chongqing Heavy Aluminum company use high strength aluminum panel for production. Normally the material is AA3003 H24.

Thickness(mm): 2.0, 2.5, 3.0, 4.0.

Curtain wall aluminum veneer consist of face layer sheet, reinforcing bar, suspension loop. The suspension loop is molded by bending and pressing the face plate or riveting a corner connector on the face plate. The weld screws at the back of face plate and reinforcing bar are connected with face plate to greatly increase the strength of the panel and keep the flatness and wind resistant function in a long period.

 

 

Curtain wall aluminum veneer surface after degreasing, pickling, passivation and other pre-treatment, and then use fluorocarbon spraying treatment, which is generally divided into two coatings, three coatings or four coatings. Fluorocarbon coating topcoat and varnish contain polyvinylidene fluoride resin(KANAR500), fluorocarbon coating has excellent corrosion resistance and weather resistance, can resist acid rain, salt fog and a variety of air pollutants, can resist strong ultraviolet radiation, can maintain long-term colorfast, non-pulverizing, and the service life is more than 20 years.

 

 

http://www.heavy-aluminum.com/